What Is The Difference Between Good And Bad Tape In Use?
- Jan 04, 2019 -

In fact, the purpose of using tape is not to stick to the problem, but to stick it firmly and not to separate. Nowadays, most of the impurity-doped tapes will collapse after a period of packaging (20 to 1 hour), and they cannot be pasted again, especially in low temperature environments and windy More obvious in dry conditions.


Once again, the inferior tape is easy to break, and the strength of the tape is very low, mainly related to the quality of the film. The tape paper tubes produced by the regular enterprises all use paper tubes with higher density, and the cut surface is free of paper dust, and the tape with a thickness of 100 meters or less is 3 mm, and the tape with a thickness of 100 meters or more is 4-5 mm, while the small enterprise is The use of thick paper tubes for blinding consumption is usually 5-7 mm thick, which is relatively large in appearance, but the thickness is obviously compared.

 

Therefore, when selecting the tape, be sure to see the width of the tape and the thickness of the tape. Also note that the tape is not covered with a lot of impurities due to the inferior tape, so there is an undetectable gap between the tapes when the strip is taken, so the same number of meters In the case of a large volume, it will blind the consumption.


The quality of the tape has a certain influence during use. The poor quality tape will fall off after a period of use and cannot be pasted again, but the good quality tape will not.


    JOIN US